Motorola TC75 Quick Start Manual

FEATURES
TC75
QUICK START
Note: Remove protective shipping film that covers the touch screen, exit
window and camera window before using.
GUIDE
11
12
13
14
15
1
2
3
4
1 Scan Button
2 PTT Button (programmable)
3 Back Button
4 Home Button
5 Power Input
6 Search Button
7 Menu Button
Note 1: To reset the TC75, press and hold the Power button until the menu
appears and then select Reset.
23
10
16
9
17
18
8
22
19
7
6
20
16 Hand Strap Mounting Point 20 Exit Window
17 Rear-facing Camera
21 Volume Button
18 Camera Flash
22 Battery Release Latch
19 Interface Connector
23 Hand Strap
5
Notifications
8 Touch Screen
Data Capture LED:
9 Light Sensor
Green: Good Decode
Red: Data capture in process
10 Proximity Sensor
Charging/Notification
Blue: Application notification
11 Power Button
Data Capture
12 Receiver
Charging\Notification LED:
13 Charging/Notification LED
Slow blinking amber: Battery charging
14 Data Capture LED
Solid green: Fully charged
15 Front-facing Camera
Fast blinking amber: Charging error
Slow blinking red: Charging aged battery
Solid red: Fully charged aged battery
Fast blinking red: Charging error aged battery
Slow blinking blue: Application notification
SIM/SAM CARD INSTALLATION SD CARD INSTALLATION
1. Lift the access door. 1. Lift the access door.
2. Insert the SIM/SAM card into the card holder. Push the card all the way into the 2. Insert the microSD card into the card holder. Push the card all the way into the
card holder. card holder.
NOTE : NOTE :
21 Proper position of the SIM/SAM card — the card connector (i.e., gold contacts) Proper position of the microSD card — the card connector (i.e., gold contacts) should
should be facing down. Nano Slot 1 is default slot for SIM card. Goto Settings to be facing down.
configure the default SIM slot, if enabled by your system administrator.
SIM or SAM Card Nano SIM Card
Nano Slot 1 Nano Slot 2
(default)
3. Replace the access door. Ensure that it is
properly seated.
3. Replace the access door. Ensure that it
is properly seated.
HANDSTRAP AND BATTERY INSTALLATION
1. Remove hand strap filler plate. 4. Rotate the battery down into the battery compartment and press the battery
down until it snaps into position.
2
2. Insert the hand strap plate into the handstrap slot.
5. Place the hand strap clip into the hand strap attachment slot and pull down to lock into
place.
3
3. Insert the bottom of the battery into the battery compartment.
6. Lift the hand strap ribbon off the hook material.
4
7. Slide the pad and adjust the ribbon for best fit.
8. Press the ribbon down to secure to hand strap.