Progress PAI8105I User Manual page 15

The rating plate is on the bottom of the
hob.
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in units
and work surfaces that align to the
standards.
Connection cable
• The hob is supplied with a connection
cable.
• To replace the damaged mains cable,
use the cable type: H05V2V2-F which
withstands a temperature of 90°C or
higher. Speak to your local Service
Centre.
Assembly
min.
500mm
Attaching the seal to the rabbet
1. Clean the rabbets in the worktop.
2. Cut the supplied seal stripe into 4
3. Cut the ends of the stripes at an angle
4. Attach the stripes to the rabbets. Do
After you assemble the hob, seal the
remaining gap between glass ceramic and
the worktop with silicone. Make sure the
silicone does not get under the glass
ceramic.
min.
50mm
min.
2mm
stripes. The stripes must have the
same length as the rabbets.
of 45°. They should fit in the corners of
the rabbets accurately.
not extend the stripes. Do not bond
ends of stripes one over another.
Progress 15