Toshiba TLP-MT7E Owner's Manual page 18

18
Floor-mounted projector placement (continued)
3
Connect the power cord.
• Insert one end in the AC IN socket on the projector.
• Insert the other end in a wall outlet.
4
Take off the lens cover.
Notes
• When the projector is moved from a cold location to a warm location, or when the ambient temperature in the projection room has risen suddenly,
moisture may condense on the lens or the internal optical section to blur the projected pictures. In such a case, leave the projector for an adequate time
(1 to 2 hours, depending on the room's condition) before using it, so it adjusts to the ambient temperature.
• If the screen is exposed to direct sunlight or other strong light, the projected picture becomes too faint to see. Shut out the light with curtains or other
means.
• If the screen and the projector are not installed properly, the projected picture may be distorted.
TEMP LAMP
BUSY
Power cord
(Supplied)
ON
Light (Orange)
FAN
The three indicators, TEMP, LAMP, and ON, light in
green for several seconds and then the ON indicator
lights in orange and the projector turns to the standby
mode.
Do not perform any operations while the three
indicators are lit green.