Table of Contents
Advertisement
Preparing the remote control
Inserting and removing the batteries
(i)
1)
Open the cover. (Fig. 1)
2)
Insert the batteries and close the cover (insert the m side first). (Fig. 2)
f When removing the batteries, perform the steps in reverse order.
When using multiple projectors
When you use multiple projectors together, you can control all the projectors simultaneously or each projector
individually using single remote control, if a unique ID number is assigned to each projector.
When using the projectors by setting the ID numbers, set the ID number ([1] - [6]) of the projector body after initial
settings have been completed. Then, set the ID number of the remote control.
For initial settings, refer to "When the initial setting screen is displayed" (x page 40).
The factory default ID number of the projector (projector body and remote control) is set to [ALL], so you can use
it as it is. Set the ID numbers of the projector body and remote control as necessary.
For details on setting the ID number of the remote control, refer to "Setting the remote control ID numbers"
(x page 49).
Note
f Set the ID number of the projector body from the [SETUP] menu → [PROJECTOR ID].
Chapter 1 Preparation — Preparing the remote control
(ii)
Fig. 1
(i)
Fig. 2
ENGLISH - 27
Advertisement
Table of Contents
