Dahua Technology 22204TNI Quick Start Manual

Dahua Technology 22204TNI Quick Start Manual

2 mp network mini ptz camera

Advertisement

Quick Links

2 MP Network Mini PTZ Camera
22204TNI
Quick Start Guide
Version 001.001
Dahua Technology USA Inc.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 22204TNI and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Dahua Technology 22204TNI

  • Page 1 2 MP Network Mini PTZ Camera 22204TNI Quick Start Guide Version 001.001 Dahua Technology USA Inc.
  • Page 2: Table Of Contents

    Table of Contents Welcome........................1 Important Safeguards and Warnings..............1 Electrical safety ....................1 Environmental Precautions ................2 Operation and Daily Maintenance ..............3 Lifting Appliance Requirement ................3 Warnings ......................3 FCC Information ....................4 FCC compliance: .................... 4 Legal Notices ....................
  • Page 3: Welcome

    1 Welcome This manual offers reference material and general information about the basic operation, maintenance, and troubleshooting of a Dahua Network PTZ Camera. Read, follow, and retain the following safety instructions. Heed all warning on the unit and in the operating instructions before operating the unit.
  • Page 4: Environmental Precautions

    • If the unit is damaged and requires service, unplug the unit from the main AC power supply and from the PoE supply and refer to qualified service personnel. Damage may include, but is not limited to: • The power supply cord or plug is damaged. •...
  • Page 5: Operation And Daily Maintenance

    Operation and Daily Maintenance • Do not touch the heat dissipation component of the unit. This part of the unit is hot and may cause a burn. • Do not open or dismantle the device; there are no components that a user can fix or replace. Opening the unit may cause water leakage or expose components to direct light.
  • Page 6: Fcc Information

    1.3 Legal Notices Copyright This user guide is ©2018, Dahua Technology Company, LTD. This user guide is the intellectual property of Dahua Technology Company, LTD and is protected by copyright. All rights reserved. Trademarks All hardware and software product names used in this document are likely to be registered...
  • Page 7: Disclaimer

    1.4 Disclaimer • This user guide has been compiled with great care and the information it contains has been thoroughly reviewed and verified. The text was complete and correct at the time of printing. This guide may be periodically updated to reflect changes to the product or to correct previous information and the content of this guide can change without notice.
  • Page 8: Unpacking

    2 Unpacking This equipment should be unpacked and handled with care. If an item appears to have sustained damage during shipping, notify the shipper immediately. Verify that all the parts listed below are included. If an item is missing, contact customer support or your local representative.
  • Page 9: Installation And Configuration

    3 Installation and Configuration 3.1 Framework and Dimensions The following figures show the dimensions of the device in mm (in.). These images are intended as a reference only. Figure 3-1: Dimensions 3.2 Locally Storing Data Certain cameras include a SDHC card slot for onboard storage that support a 128 GB Micro SD card. Dahua recommends using a SanDisk Extreme Micro SD card (or an equivalent substitute) as these cards have been fully tested without issue and the SanDisk Extreme line is better suited for constant recording.
  • Page 10: Device Installation

    4 Device Installation This section details installing the camera to a solid wall or to a ceiling, in an outdoor or an indoor environment. Note that the wall or ceiling must be capable of supporting a minimum of eight (8) times the weight of the camera and a bracket (if used).
  • Page 11: Insert A Micro Sd Card

    4.2 Insert a Micro SD Card Open the cover for the SD Card slot. Insert the Micro SD Card into the Micro SD Card slot. Replace the cover. Figure 4-1 4.3 Mounting the Camera to a Ceiling...
  • Page 12 Place the mounting template against the ceiling and mark the location of the center hole and the three perimeter mounting holes. Determine the route of the outgoing cables, either a center route through the ceiling medium or a side exit to a grounded conduit. If the cables are routed through the ceiling, then place the pedestal seal ring into the slot on the side of the camera base.
  • Page 13: Network Configuration

    5 Network Configuration Dahua IP cameras feature a built-in Web interface to control all aspects of camera operation. This section includes details about the supported network protocols, configuring IP addresses, and configuring alarms and local recording options. Refer to the camera’s Operations Manual for full details.
  • Page 14: Modifying The Ip Address

    5.2 Modifying the IP Address To operate the camera in your network you must assign it a valid network IP address. The default IP address is 192.168.1.108, but you may have to change this address if it conflicts with another device on the network.
  • Page 15: Accessing The Web Interface

    5. Click the Net icon at the top of the ConfigTool. 6. Modify the IP Address and any other applicable network parameter. 7. Click Save to finish modification and store the modified network parameters. Figure 5-2 5.4 Accessing the Web Interface Each camera can be accessed directly from the Internet Explorer Web browser.
  • Page 16: Configuring Local Sd Card Recording

    5.5 Configuring Local SD Card Recording The devices Web interface contains settings to control the recording medium and to configure an alarm that triggers once the Micro SD card passes a pre-determined storage. 1. Access the Web Interface for the device and click the Setup tab. Expand the Storage menu, then choose the Destination page.
  • Page 17 Figure 5-6 5. Select the event from the Event Type pull-down menu (No SD Card, Capacity Warning, SD Card Error). 6. Check the Enable box to activate the alarm for this event. 7. Check the Relay-out box to enable a relay alarm. Then, specify the time in seconds to delay the alarm relay output (10 s to 300 s).
  • Page 18 Dahua Technology USA Inc. 23 Hubble, Irvine, CA 92618 Tel: (949) 679-7777 Fax: (949) 679-5760 Email: sales.usa@global.dahuatech.com Rev 001.001 © 2018 Dahua. All rights reserved. Design and specifications are subject to change without notice.

Table of Contents