LG Ipsolute LW130W-D Owner's Manual page 11

Device Overview & Features
Stand Connecting Hole
a
You can connect the camera onto a stand using this
hole.
b I/O Terminals
IN (Sensor Input) Terminal: Connect a sensor here.
OUT (Relay output) Terminal: Connect an alarm (relay)
device here.
c Power Socket
Connect a DC 5 V power supply.
d Ethernet Terminal
Use a 10 BASE-T/100 BAST-TX network cable to connect
to a PC or a network hub.
e REBOOT
Push this button to restart the device.
f WPS, Factory Setting
Press to use WPS or return the device to factory default
setting. Hold the button down for less than 4 seconds to
activate WPS feature.
Hold the button down for longer than 10 seconds to
activate the factory default mode. Once the power lamp
starts to blink in yellow and green, release the button to
run in factory default model.
When a WPS connection is established, the Wireless LAN
Connection lamp will blink in red and green colors. Once
the lamp turns green and stops blinking, the connection
establishment is complete. Red color of the connection
lamp means a connection failure.
Note:
Refer to the manual of the network hub or the internet
service manual to find out how to use WPS. If the hub is
set to Shared mode, connection to the hub using WPS
cannot be established.
g micro SD Card Slot Cover
11