Adjusting Engine Runtime Settings; Key Takeover Following Remote Start - idatastart HC3 Owner's Manual

8

ADJUSTING ENGINE RUNTIME SETTINGS

Once remote started from your factory key fob or long-range remote, your vehicle will run for the
programmed 'runtime' setting. The default runtime is 15 minutes but it can also be programmed for
3, 5, 10, 25, 30 or 35 minutes. If you wish to change your remote start runtime setting, contact your
iDataStart Authorized Dealer.

KEY TAKEOVER FOLLOWING REMOTE START

Available on some vehicles, the 'key takeover' procedure ensures that your engine does not turn off
when entering the car during the remote start runtime, following a remote start command. Follow the
instructions below or scan the QR code to view a video tutorial.
For Standard Key Vehicles
1. Unlock and enter vehicle
2. Close doors
3. Insert key into ignition and turn ignition to ON position
4. Press foot brake
For Push-To-Start Vehicles
1. Unlock and enter vehicle with valid smartkey
2. Close doors
3. Press foot brake
NOTE: To prevent your vehicle from shutting down, complete the steps above within the programmed
delay time (45 seconds, 90 seconds, 3 minutes or 4 minutes). Key takeover procedure may vary by
vehicle, ask your iDataStart HC3
IDATASTART OWNER'S GUIDE
Authorized Dealer for deatails.
CUSTOMER SUPPORT: 866.427.2999 / WWW.IDATASTART.COM
http://q-r.to/2ixD
http://q-r.to/2iwz