Upgrading Your Flex Remote Configuration; Replacing Remote Batteries; Remote Starting From Your Factory Key Fob - idatastart HC3 Owner's Manual

UPGRADING YOUR FLEX REMOTE CONFIGURATION

Want to upgrade the confguration of your iDataStart HC3 remotes? Please take note of the following:
1. A functional iDataStart HC3 system with FLEX 1W or FLEX 2W remote configuration must already be
installed in your vehicle.
2. All upgrades must be programmed by an iDataStart Authorized Dealer. Upgrade fees will apply.

REPLACING REMOTE BATTERIES

Follow the steps below to replace the batteries in your iDataStart HC3 remotes OR scan the QR code
below to view a video tutorial.
1. Insert a 25 cent coin into the hollow (bottom left) corner of your iDataStart remote.
2. Gently twist the coin and move it along the seam until the casing pops open.
3. Use your coin to pry open the rest of the case perimeter.
4. Slide the old battery out of its enclosure and replace with the new battery.
5. Snap top and bottom casings back together using your hands.
REMOTE STARTING FROM FACTORY KEY FOB
Available on most vehicles, your iDataStart HC3 system can enable remote start functionality from your
factory key fob as follows:
BUTTON
Remote start range will vary by key fob. Ask your iDataStart HC3 Authorized Dealer for details.
IDATASTART OWNER'S GUIDE
PRESS
3x rapidly
3x rapidly
CUSTOMER SUPPORT: 866.427.2999 / WWW.IDATASTART.COM
7
http://q-r.to/1h9x
FUNCTION
Start engine
Stop engine