Configuration Wiring; Maintenance; Fusing Requirements; Serial Port Connections - Maple Systems HMI5000B Series Installation Manual

10

Configuration Wiring

To configure the HMI using the EasyBuilder Pro software, use the
Ethernet Configuration Cable (P/N 7431-0104).
If using a switch or router between the PC and the HMI, use a straight-
through or crossover cable as required by the switch or router.
In order to download a project to the HMI over Ethernet, the HMI must be
assigned a unique IP address that is on the same subnet as the
development PC.
Follow these steps to enter the System Settings menu and assign the
HMI an IP address:
1. Apply power to the HMI.
2. Click the arrow icon located in the lower-right corner of the screen.
3. Click the gear icon to enter the system settings menu
4. When prompted, enter the system password (default: 111111).
5. Navigate to the Network tab.
6. Enter the desired IP address, or select Obtain an IP Address Automatically
to enable DHCP.
7. Click Apply to save the changes, and OK to exit the system settings menu.
8. The updated IP address will appear in the system information window, also
accessed via the arrow icon. For more information on Ethernet configuration
options, please refer to the EasyBuilder Pro Programming Manual.

Maintenance

Fusing Requirements

If the display does not come on within two seconds of power up, remove
power. An internal fuse will prevent damage if the polarity of the DC
power is incorrect. Check wiring to ensure proper connections and try to
power up again.
USB
The USB Host port is designed for data storage only. If connecting a
USB hard drive, power the drive with its own power supply. Do not
charge any device from the USB port.

Serial Port Connections

The diagrams on the next page indicate the proper pin connections for
the serial ports of the HMI.
1010-1051 Rev 02
HMI5000B Installation Guide
www.maplesystems.com