Wireless Problems - ZyXEL Communications BG-418N v1 User Manual

You will lose all of your changes when you push the RESET button.
To reset the NBG-418N,
Make sure the power LED is on.
1
Press the RESET button for longer than 1 second to restart/reboot the NBG-418N.
2
Press the RESET button for longer than five seconds to set the NBG-418N back to its factory-
3
default configurations.
If the NBG-418N restarts automatically, wait for the NBG-418N to finish restarting, and log in to the
Web Configurator. The username is admin and password is 1234.
If the NBG-418N does not restart automatically, disconnect and reconnect the NBG-418N's power.
Then, follow the directions above again.

20.5 Wireless Problems

I cannot access the NBG-418N or ping any computer from the WLAN.
Make sure the wireless LAN is enabled on the NBG-418N.
1
Make sure the wireless adapter on the wireless station is working properly.
2
Make sure the wireless adapter installed on your computer is IEEE 802.11 compatible and supports
3
the same wireless standard as the NBG-418N.
Make sure your computer (with a wireless adapter installed) is within the transmission range of the
4
NBG-418N.
Check that both the NBG-418N and your wireless station are using the same wireless and wireless
5
security settings.
Make sure traffic between the WLAN and the LAN is not blocked by the firewall on the NBG-418N.
6
Make sure you allow the NBG-418N to be remotely accessed through the WLAN interface. Check
7
your remote management settings.
• See Chapter 6 Wireless LAN
I cannot access the Web Configurator after I switched to a non-router mode.
for more information.
Chapter 20 Troubleshooting
145