Table of Contents
Advertisement
5.3 Enable and Configure Wireless Security without WPS
on your NBG-418N
This example shows you how to configure wireless security settings with the following parameters
on your NBG-418N.
SSID
Channel
Security
Follow the steps below to configure the wireless settings on your NBG-418N.
The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see
Open the Wireless LAN > General screen in the NBG-418N's Web Configurator.
1
Make sure the Enable Wireless LAN check box is selected.
2
Enter SSID_Example3 as the SSID and select a channel.
3
Set security mode to WPA-PSK and enter ThisismyWPA-PSKpre-sharedkey in the Pre-Shared
4
Key field. Click Apply.
Figure 42 Tutorial: Network > Wireless LAN > General
Open the Status screen. Verify your wireless and wireless security settings under Device
5
Information and check if the WLAN connection is up under Interface Status.
SSID_Example3
6
WPA-PSK
(Pre-Shared Key: ThisismyWPA-PSKpre-sharedkey)
Chapter 5 Tutorials
Section 2.2 on page
17).
61
Advertisement
Table of Contents
