Basic Functions
Plug and Play (for tuner installation)
Plug and play allows you to store all available
radio stations automatically.
If plug and play has not been installed
1
When you turn on the system, "AUTO
INSTALL- PRESS PLAY" will be displayed.
2
Press 38 on the system to start installation.
➜
"TUNER" will be displayed and followed by
"AUTO".
➜
PROG will start to flash.
➜
The system will search all radio stations on
the FM band, and then the MW band.
➜
All available radio stations with strong signal
strength will be stored automatically.
➜
The system will stop searching when all
available radio stations are stored or when the
memory for 40 preset radio stations is full.
➜
The first preset radio station will play when
Plug and Play is completed.
To exit without storing the plug and play
●
Press 7 on the system.
Notes:
– When the power is turned on, the disc tray may
open and close to initialize the system.
– If Plug and Play installation is not completed, it
will be reinitiated the next time you power on the
system.
– If auto-install is not preset, the system will store
the radio station automatically.
18
Demonstration mode
The system has a demonstration mode that
shows various features offered by the system.
Activating demonstration
●
In Standby mode, press and hold STOP 7 for
more than 5 seconds to activate demo mode.
➜
"DEMO ON" is displayed.
➜
Demonstration will begin.
Deactivating demonstration
●
Press and hold STOP 7 on the system until
"DEMO OFF" is displayed.
➜
The system will switch to Standby mode.
Note:
– Even if you remove the AC power cord and
reconnect it to the wall socket, the demonstration
will remain off until you activate it again.