IMPORTANT!
Before you operate the system, complete
the preparation procedures.
Plug and Play
Plug and Play allows you to store all available
radio stations automatically.
First time setup/power up
1
When you turn on the main supply, "AUTO
INSTALL - PRESS PLAY" is displayed.
2
PressÉ Å to start installation.
➜
"PLUG AND PLAY" .... "INSTALL" is
displayed, followed by "AUTO".
➜
All available radio stations with sufficient signal
strength will be stored automatically, starting
from FM and followed by AM band.
➜
When all the available radio stations are
stored or the memory for 40 presets are used,
the first preset radio station will be played.
To reinstall Plug and Play
1
In standby mode, press and holdÉ Å until
"AUTO INSTALL - PRESS PLAY" is displayed.
2
PressÉ Å again to start installation.
➜
All previously stored radio stations will be
replaced.
(for tuner installlation)
Basic Functions
To exit without storing the Plug and Play
●
Press Ç.
➜
If you do not complete the Plug and Play
installation, the function will be restarted when
you next turn on the main supply again.
Notes:
– When the power is turned on, the disc tray may
open and close to initialise the system.
– If no stereo frequency is detected during Plug
and Play, "CHECK ANTENNA" will be displayed.
– During Plug and Play, if no button is pressed
within 15 seconds, the system will exit Plug and
Play mode.
Switching the system on
●
Press 2.
➜
The system will switch to the last selected
source.
●
Press DISC (or DISC 1/2/3, CD 1/2/3),
TUNER, AUX/MP3 LINK (or AUX) or USB.
➜
The system will switch to the selected source.
●
Press OPEN•CLOSE or DISC CHANGE.
➜
The system will switch to the disc source and
the disc tray will open.
13