Table of Contents
Advertisement
USB Operation
USB playback
1
Check the USB device has been properly
connected .
2
Press USB on the system (or USB on the
remote control), "USB" will display 2 seconds on
the VFD and " USB INIT" will display 6
seconds, then "READING" will be displayed.
Note:
- If there was no USB device inserted, "NO USB"
will be display.
3
Play the USB's audio files as you do with the
albums/tracks on a MP3 disc.
Note:
- For compatibility reasons, the album/track
information may differ from what it is displayed
through flash players' music management software.
- File names or ID3 tags will be displayed as ----If
they are not in English.
– Compatibility of the USB connection on this
product:
a) This product supports most USB Mass storage
devices (MSD) that are compliant to the USB
MSD standards.
i) Most common Mass storage class devices are
flash drives, memory sticks, jump drives and etc.
ii) If you see a "Disc Drive" show up on your
computer after you plugged the mass storage
device into your computer, most likely it is MSD
compliant and it will work with this product.
b) If your Mass storage device required a battery/
power source. Please make sure you have a fresh
battery in it or charge the USB device first and
then plug it into the product again.
42
– Supported Music type:
a) This device only supports unprotected music
with the following file extension:
.mp3
.wma
b) Music bought from on-line music stores are not
supported because they are secured by Digital
Rights Management protection (DRM).
c) File name extensions that end with the
following are not supported:
.wav; .m4a; .m4p; mp4; .aac and etc.
– No Direct connection can be made from
Computer USB port to the product even you have
either or both mp3 or wma files in your computer.
Advertisement
Table of Contents
