Advertisement
18
Install 2 of the screws to the side panel of
mounting bracket corresponding to the
open slotted holes on the canopy upper
rim, screws provided. Remove the thread
studs from the lower part of the mounting
bracket.
Lift fan to mounting bracket, aligning the
"L" shape holes on canopy with the
screws on the mounting bracket. Turn the
fan clockwise to lock in position. Install
the other 2 canopy mounting set screws
from the hardware pack and tighten all
screws securely.
21
Loosen 2 and remove 1 preassembled
screw
from top plate of switch housing.
© 2018 Monte Carlo Fan Company
19
Blade bracket
Install blade bracket with blade by 3 blade
screws and washers provided. Tighten
screws securely. Repeat this process for
remaining blades.
22
Connect the quick connectors from fan
and switch housing. Make sure quick
connectors are clasped firmly.
Install the switch housing onto the top
plate, aligning the keyhole slots on
the switch housing with the
preassembled screws on top plate and
twist it clockwise till lock. Reinstall the
set screw removed in step 21 and
tighten all screws securely.
Install fan pull chain to preassembled pull
chain on fan. Pull chain provided.
6
20
Blade
Shipping stabilizers
Remove shipping stabilizers from motor
assembly.
Install the blade assembly to motor using
the preinstalled screws. Tighten screws
securely. Repeat this process for
remaining blade assemblies.
Reverse switch
Setting the reverse switch in the left hand
side will result in downward airflow and
setting the switch in the right hand side
will result in upward airflow.
Note: Reverse switch must be set either
way completely. If the reverse switch is
set in the middle position, fan will not
operate.
10/2018
Advertisement
