Kohler K-80021T-KP060-01R Installation Manual page 8

Step 3: Installing Filter Cartridge & Replacing Filter
Cartridges
NOTE: Before changing the filter, please make sure the cold
water valve is turned off.
Remove and discard the dustproof cap (sanitary
!
protective cap) from the cartridge;
Verify both O-rings are present and positioned correctly in
!
the grooves;
Push the filter cartridge into the filter base align the hollow
!
icon of the cartridge with the hollow icon on the filter base,
then turn cartridge clockwise until the hollow icon of the
cartridge were aligned the color filled icon on the filter
base, it will be fully installed. (Figure 9)
Rotate 90 degree & Pull out the old filter.
90
Please replace filter when prompted by the indicator.
!
System Model
First Stage
Second Stage
Third Stage
NOTE: Filtration performance varies depending on local
water quality.
When filters replaced remember to push and hold the
!
corresponding reset button to the filter for 5 seconds until
the indicator automatically with 2 short beep, then
corresponding orange LED light turn to white. (Figure 10)
NOTE: After the filter is replaced, the corresponding button
can be reset only. If not, the filter life indicator can't be
accurate. No need to reset after the first installation.
1348118-T01-E
!
!
!
Change new filter matched the button colour.
Fig.#9
9
!
KP060 (
80041T-R1-01R
80051T-R2-01R
80041T-R3-01R
!
Press RESET button
for 5 seconds to reset
RESET 5
Fig.#10
10
-7-
O
90
Aim at the dot, rotate 90 degrees to fix.
90
K-80021T-KP060-01R )
KC
KPR
KC
( 10)
( 9)
5