Table of Contents
Advertisement
Step 2: Making connections
Refer to Figure 5, insert the 3/8" Plastic tubing into the
!
filter inlet port and the water supply adapter, insert the
1/4" Plastic tubing into the filter outlet port and the end of
the Water filtration faucet; Then insert the a 1/4" Plastic
tubing into the Drain port of RO system and the Drain line
under the sink. (Figure 5)
Hot Water Supply Valve
Fig.#5
5
Electronic Faucet Signals
(Only with Matchable Faucet)
(
Not Apply In This System
Product Water (1/4")
Raw Inlet (3/8")
(3 )
Drain Water (1/4")
The Carafe system features reliable and convenient push-to-connect tubing connectors. Tubing is easily connected and
disconnected from these fittings as follows. (Figure 7 and
Fig.#7
To Attach Tubing
7
2
1
Push tubing in as
Tubing must be inserted
far as it can go
past O-ring and hit
backstop
Note: It may be difficult to release the tubing due to water
pressure when replacing service parts. In this case, please
shut off the cold water supply valve, turn on the Water
filtration faucet to depressurize and then try to release the
tubing again.
1348118-T01-E
Tap Faucet
3/8" Plastic
Tubing-Raw Water
3
)
Power
(2 )
(2 )
Not Apply In This System
3
Insert the locking clip
O
5
!
Water Filtration Faucet
Drain Saddle Clamp Kit
1/4" x 1/2" Male Thread Faucet Adapter
2
4
1/4" Plastic Tubing-Product Water
2
Water Supply Adapter
Cold Water Supply Valve
1/4" Plastic Tubing-Drain Water
2
Tubing Connectors
Correct Cut
Note: Cut tubing straight with a utility knife, make sure there
are no cuts, nicks, flat spots or sharp edges as figure 5, If
any of these are present, cut the tubing again; Do not kink
tubing. ( Figure 6)
Figure
8)
( 7
8)
To Release Tubing
1
Pull out locking clip
-6-
3
( 5)
Connections to undersink plumbing can be
made with a saddle clamp designed to
accept the drain tubing from the RO
system. Kohler offers a saddle kit, PN
1275904, designed for 40mm undersink
drain plumbing (Figure 13).
Be sure to check and follow local
plumbing codes prior to installation.
1275904
40mm
Fig.#6
Incorrect Cut
6
( 6)
Fig.#8
8
2
3
Push in collect to release tubing.
With collect held, pull tubing straight out.
2
RO
RO
Advertisement
Table of Contents
