Table of Contents
Advertisement
Servo monitor
This is used for testing servo movement. "Moving
Test" (repetition mode) and "Neutral Test" (fixed
position mode) are available.
The "Neutral Test" is good for finding the neutral
position of a servo horn.
● Select [Servo monitor] at the linkage menu and
call the setup screen shown below.
＜ or ＞
● Long press the [U.MENU/
M O N . ] b u t t o n i n t h e
Home screen to call the
setup screen shown.
●Return to Home or
Linkage menu
[Moving]: Mode which repeats operation of
each servo
Servo Test & Graph Display / Displays servo positions.
In order to prevent any potential difficulties,
the servo test function will be inoperable, or
inaccessible, under certain conditions. Specifically,
the Servo Test function is not operational if the
Throttle cut is ON in either airplane or helicopter
modes; or if the Throttle hold is ON in helicopter
mode.
Each channel movement can be checked.
Select the [OFF] or pushing the
HOME/EXIT button → Testing is
stopped
■Inadvertent rotation of the motor or acceleration of the engine
63
Test mode change :
OFF → Neutral → Moving
[Neutral]: Mode which locks each servo in the
neutral position
WARNING
Don't set a servo test mode when the
drive motor is connected and the engine
has been started.
is extremely dangerous.
Advertisement
Table of Contents
