Control Panel Buttons; Power; Uid And Bmc Reset Button; Control Panel Leds - Supermicro SC846B JBOD User Manual

SC846B JBOD Chassis Manual
3-2

Control Panel Buttons

The chassis includes two push-buttons that control power to the system.

Power

The main power switch applies or removes primary power from the power supply to
the JBOD Control Board but maintains standby power. To perform most maintenance
tasks, unplug the system to remove all power.

UID and BMC Reset Button

•
Press briefly to toggle the UID alert light. The blue LED will blink.
•
Press and hold 6 seconds to set the BMC IP address to 192.168.1.99. The
blue LED will blink.
•
Press and hold 12 seconds to restore factory defaults. The blue LED will remain
on.
3-3

Control Panel LEDs

There are four LEDs that provide status information about the system.
Power
Indicates power is being supplied to the system power supply units. This LED is
illuminated when the system is operating normally.
1

NIC1

Indicates network activity on GLAN1 when flashing.
3-2