Operating By Remote Control; Maintenance; Cleaning - Napoleon JAYDEN NEFL50B-CTC Installation And Operation Manual

5.2

operating by remote control

Plug in your electric appliance.
A.
Ensure the appliance's power switch is in the "|" position (on). The remote control will not work if the
B.
main power switch is at the "O" position (off).
When operating the remote control, it must be directed towards the front center of the appliance.
C.
The button at the top right of the remote can be used to power up or down the
D.
appliance (the main power switch on the appliance must be in the "on" position for
the remote to operate). Pressing this button activates the power to the appliance.
To make the flame higher and brighter, press the "flame +" button.
E.
To make the flame smaller and dimmer, press the "flame -" button.
F.
To activate the heater, press the heater button. The heater will blow cool air for 10
G.
seconds before the heat turns on and after it turns off. This prevents the appliance
from overheating.
To adjust the timer press the timer button. There are 15 programmable settings,
H.
30 mins, 1h, 1.5h, 2h, 2.5h, 3h, 3.5h, 4h, 4.5h, 5h, 5.5h, 6h, 6.5h, 7h, 7.5hrs
maximum.
To turn off the appliance, press the power button once.
I.
note:
This remote control must remain within 26 feet (8 meters) of the appliance to be effective and this range may be
reduced as the battery power is depleted.

6.0 maintenance

6.1

cleaning

note:
Always turn off the appliance and unplug from the outlet before performing any cleaning or maintenance. Failure
to do so could result in electric shock, fire, or personal injury.
For metal components, use a soft cloth and dampen with a metal safe cleaning product.
A.
(Do not use brass polish or household cleaners that can damage the metal trim)
For glass components, use a glass cleaner sprayed onto a cloth. Dry with a lint free cloth.
B.
(Do not use abrasive cleaners or any cleaner that can scratch the surface)
For vents, use a vacuum with a soft brush or a duster to remove any dust or lint.
C.
For plastic components, slightly dampen a cloth with a mild solution of dish soap and warm water.
D.
(Do not use abrasive cleaners or any cleaner that can scratch the surface)
operating instructions
W415-1717 / 02.28.17
EN
13