Operating By Remote Control - Napoleon Cinema NEFB27HG Installation And Operating Instructions Manual

4.2

OPERATING By REmOTE CONTROL

TO AvOId dANGER OF SuFFOCATION kEEP THE PACkAGING BAG AwAy FROm BABIES ANd
CHILdREN. dO NOT uSE IN CRIBS, BEd, CARRIAGES OR PLAy PENS. THIS BAG IS NOT A TOy.
NOTE: when operating the remote control, it must be directed towards the front center of the appliance.
The power button can be used to turn the appliance on/off. Pressing
a.
this button
button again will turn off the appliance. The ember and log will fade after
4 seconds after turning off the appliance.
To adjust the flame brightness and ember log light, press the flame
B.
button . There is one ember log light and three flame brightness
levels to cycle through and then an off setting ( LL, F1, F2, F3 and then
F0).F3 is the brightest flame level, LL is the ember log light only.
To control the thermostat function press the thermostat button
C.
There are 7 temperature settings (61°F, 64°F, 70°F, 75°F, 81°F 85°F and
off). The default setting will display Fahrenheit. Press the thermostat
button to cycle through the settings. Once you have selected the
desired temperature the heater will automatically operate until that
temperature is reached. When the room temperature is 2 degrees lower
than the temperature setting, the heater will turn on.
To activate the heater and blower, press the heater button
d.
will turn on. Press the heater button again to set desired low or high
heat temperature; press the heater button again to turn off the heater.
The timer controls all operating modes of the appliance. To activate the
E.
timer, press the timer button
will appear on the LED display. To choose the desired time, continue to
press the timer button, there are 8 settings (30mins,1h, 2h, 3h, 4h, 5h,
6h and off). The fireplace will turn off at the setting time.
To activate the decoration light, press the light button
f.
three settings to cycle through and then an off setting (d1, d2, d3 and
then d0). d1 white colour, d2 colour cycles from White / Orange / Blue / Orange-Blue / White-Orange
/ White-Blue. It will take 8.5 seconds to switch from one colour to the next when in d2 setting, d3 will
lock to a desired colour.
To turn off the appliance, press the power button once on the remote, or press the power button once
g.
on the control panel on the unit.
NOTE: This hand held remote control must remain within 6 meters or 19 feet of the appliance to be
effective.
!
kNOT BEFORE THROwING AwAy.
activates the power to the appliance. Pressing the power
, the icon will illuminate and the time
WARNING
.
, the blower
.There are
13
EN
W415-1662 / 05.17.16