Table of Contents
Advertisement
6.0 OPERATING INSTRUCTIONS
The controls are located on the bottom right corner
of the appliance.
A.
Plug in your electric appliance.
B.
Main ON/OFF Power Switch and LED:
This switch is located on the right side of the
control panel. The "|" indicates ON and "O"
indicates OFF.
When the appliance is fi rst turned on, the
default settings are as follows:
- Ember bed: HIGH
- Flame: HIGH
- Appliance: OFF
C.
Flame Control Button:
After power is turned on, push the FLAME
control button to adjust the fl ame and ember bed brightness. Press and release the Flame Control
Button to cycle through LO, MED,HI and OFF.
6.1
OPERATING BY REMOTE CONTROL
A.
Plug in your electric appliance.
B.
Make sure the appliance's main power button
position! The remote control will NOT work if the main Power button
is at the OFF position. NOTE: Ensure the house circuit breakers
for the power supply are turned on. In the event of a power
failure, when the main switch is in the ON position and the hand
held remote control is in the OFF position, the fl ame generation
lights will come on at the high setting, however the heater
remains turned off when the power is restored.
C.
When operating the remote control, it must be directed towards the
front of the appliance.
D.
The button at the top left corner of the remote is the main power
button
NOTE: The main power switch on the appliance must be in the
ON position for the remote to operate.
E.
To adjust the ember bed brightness, press the
To increase the ember bed brightness, press the
decrease the ember bed brightness, press the
are seven levels of brightness.
F.
To adjust the height of the fl ame, press the
increase the height of the fl ame, press the
decrease the height of the fl ame, press the
seven levels of fl ame effects.
G.
To turn off the appliance, press the
remote control must remain within 8 meters or 26 feet of the appliance to be effective and
range may be reduced as battery power is depleted.
NOTE: Make sure your batteries are fully charged and installed correctly in your remote
control.
. Pressing this button activates the power to the appliance.
CONTROLS FOR ELECTRIC
Remote Control
Receiver
Flame Control Button
is at the ON
"+" or "-" buttons.
"+" button, to
"-" button. There
"+" or "-" buttons. To
"+" button, to
"-" button. There are
button once. NOTE: This
FIREPLACE
FLAME
ON/OFF Power
Button
REMOTE CONTROL FOR
ELECTRIC FIREPLACE
Infrared Ray Exit
ON/OFF
-
+
-
+
W415-0759 / C / 12.21.11
13
Indicator
Light
Advertisement
Table of Contents
