Table of Contents
Advertisement
Available languages
Available languages
operation
EN
7.2
operating by remote control
WARNING
!
•
To avoid danger of suffocation, keep the packaging bag away from babies and children. Do not use in cribs, bed,
carriages or play pens. This bag is not a toy. Knot before throwing away.
note:
When operating the remote control, it must be directed towards the front center of the appliance.
1. The Power button can be used to turn the appliance on/off. Pressing the
Power button activates the power to the appliance. Pressing the Power
button again will turn off the appliance. The ember and log will fade after 4
seconds after turning off the appliance.
2. To adjust the flame brightness and ember log light, press the Flame &
Ember Light Control button. There is one ember log light and three flame
brightness levels to cycle through and then an off setting (LL, F1, F2, F3
and then F0). F3 is the brightest flame level, LL is the ember log light only.
3. To control the thermostat function, press the Temperature Control button.
There are 7 temperature settings (61°F, 64°F, 70°F, 75°F, 81°F, 85°F and
off). The default setting will display Fahrenheit. Press the Temperature
Control button to cycle through the settings. Once you have selected
the desired temperature, the heater will automatically operate until the
temperature is reached. When the room temperature is 2 degrees lower
than the temperature setting, the heater will turn on.
4. To activate the heater and blower, press the Heater Control button, the
blower will turn on. Press the Heater Control button again to set desired
low or high temperature; press the Heater Control button again to turn off
the heater.
5. The timer controls all operating modes of the appliance. To activate the
timer, press the Timer button, the icon will illuminate and the time will
appear on the LED display. To choose the desired time, continue to press
the Timer button; there are 8 settings (30mins, 1h, 2h, 3h, 4h, 5h, 6h and
off). The appliance will turn off at the setting time.
6. To turn off the appliance, press the Power button once on the remote, or
press the Power button once on the control panel on the appliance.
note:
This hand held remote control must remain within 6 meters or 19 feet of the appliance to be effective.
7.3
remote battery installation
1. To replace the existing battery, remove the battery
holder.
2. To remove the battery holder, turn the remote onto
the front side and press the left side lever towards
the center while pulling the battery holder out using
the slot provided, as shown.
3. Replace existing battery, type CR 2025, with a new
battery and reinstall the battery holder onto the
remote by sliding it into position.
4. Battery cover will 'click' into the remote control until
secure.
18
W415-1755 / 05.03.17
REMOTE
BATTERY
(REAR SIDE)
(CR 2025)
BATTERY
COVER
Advertisement
Chapters
Table of Contents
