Calibrate Energy; Special Settings; Std Mode Settings - Ginlong Solis-100K-5G Installation And Operation Manual

7. Normal operation
7.5.3 Clear Energy
Clear Energy can reset the history yield of inverter
These two functions are applicable by maintenance personnel only, wrong
operation will prevent the inverter from working properly.
7.5.4 Reset Password
This function is used to set the new password for menu "Advanced info." and "Advanced
information" (see Figure 7.19).
YES=<ENT> NO=<ESC>
Password: 0000
Figure 7.19 Set new password
Enter the right password before set new password. Press the DOWN key to move the cursor,
Press the UP key to revise the value. Press the ENTER key to execute the setting.
Press the ESC key to return to the previous menu.
7.5.5 Power Control
Active and reactive power can be set through power setting button.
There are 5 item for this sub menu:
1. Set output power
2. Set Reactive Power
3. Out_P With Restore
4. Rea_P With Restore
5. Select PF Curve
This function is applicable by maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.
.42.
7. Normal operation

7.5.6 Calibrate Energy

Maintenance or replacement could clear or cause a different value of total energy. Use this
function could allow user to revise the value of total energy to the same value as before. If
the monitoring website is used the data will be synchronous with this setting automatically.
YES=<ENT> NO=<ESC>
Energy:0000000kWh
Figure 7.20 Calibrate energy
Press the DOWN key to move the cursor. Press the UP key to revise the value. Press the
ENTER key to execute the setting. Press the ESC key to return to the previous menu.

7.5.7 Special Settings

This function is applicable by maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.

7.5.8 STD Mode Settings

Selecting "STD Mode. Settings" displays the sub-menu shown below:
1. Working Mode Set
2.
Power Rate Limit
3.
Freq Derate Set
4.
10mins Voltage Set
5.
Power Priority
6.
Initial Settings
7.
Voltage PCC Set
This function is applicable by maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.
.43.