Assembly Instructions - Central Pneumatic 65903 Set Up And Operating Instructions Manual

Symbology
Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
V~
Volts Alternating Current
A
Amperes
No Load Revolutions per Minute
n 0 xxxx/min.
(RPM)
To extend the life of your air tools and equipment, install an oiler and water filter
in series with the Air Outlet Valve (4) of the Air Compressor.
The Power Cord (31) requires the attachment of a 240 volt, grounded,
3-Prong Plug (not included). For safety purposes, only a qualified, certified, electrician
should attach a Plug to the Power Cord. Never modify the Plug in any way. To com-
ply with the National Electric Code, and to provide additional protection from the risk of
electrical shock, this product should only be connected to a 240 volt electrical outlet that
is properly grounded.
Prior to use, the Air Compressor requires the attachment of a 1/4" NPT Quick
Connector (not included) to the Air Outlet Valve (4). To do so, wrap approximately 4" of
pipe thread sealant tape (not included) around the male threads of the Quick Connector.
Then, firmly screw the Quick Connector into the Air Outlet Valve. (See Figure d.)
For technical questions, please call 1-800-444-3353.
SKU 65903

ASSEMbLY iNSTRuCTiONS

To Attach A Power Cord Plug:
To Attach quick Connector:
Page 7