Central Pneumatic 65903 Set Up And Operating Instructions Manual page 14

SidE ViEW
7. Loosen four Screws (30) which hold Motor (14) in place. Then, slide Motor toward
Large Belt Wheel to loosen tension on V-Belt (27).
(See Figures H and i.)
8. Remove loose V-Belt (27) from Large Belt Wheel and Motor Pulley (14).
(See Figure H.)
9. Install a new V-Belt (27) on Large Belt Wheel and Motor Pulley (14).
(See Figure H.)
LARGE
bELT WHEEL
FiGuRE J
10. Slide the Motor (14) back toward its original position to tighten the tension on the
V-Belt (27). NOTE: To determine the proper tension on the V-Belt, with your index
finger press down on the V-Belt. The V-Belt should deflect downward about 3/4".
If necessary move the Motor Pulley (14) toward or away from the Large Belt Wheel
until the V-Belt deflects downward 3/4". Then, retighten the four Screws (3) to se-
cure the Motor (14) in place. (See Figures i and J.)
For technical questions, please call 1-800-444-3353.
SKU 65903
SCREW
(30)
3/4"
V-bELT
(27)
SCREW SCREW
(30) (30)
FiGuRE i
ENd ViEW
MOTOR PuLLEY
(14)
Page 14