Link To Cell Settings - Panasonic KX-TGE662 Operating Instructions Manual

Link to Cell
2
MbN: "Yes" a MSELECTN
R When the cellular phone is unpaired,
the CELL indicator is turned off.
3
MOFFN

Link to cell settings

Selecting which unit receives
cellular calls
You can select which unit rings and receives
calls for a cellular line. When "All" is
selected, all handsets and the base unit ring.
1
For CELL 1: MMENUN#6271
For CELL 2: MMENUN#6272
2
MbN: Select the desired handset or "All".
a MSAVEN a MOFFN
Note:
R When you select a specific handset to
receive calls for a cellular line:
– other handsets cannot answer the calls.
– the base unit can answer the calls even
though it does not ring. However, you
can make the base unit ring by adjusting
the base unit ringer volume (page 46).
(KX-TGE670 series: page 4)
R When you change to "All" from another
setting, the base unit ringer volume also
returns to the lowest level even if the ringer
volume was changed.
R The units selected with this setting have the
alert feature (page 61) applied to them.
Auto connection to the Bluetooth
devices (cellular phones)
After pairing, your Bluetooth devices are
connected to the base unit. If you move the
Bluetooth devices out of base unit range, the
Bluetooth devices are disconnected from the
base unit. This feature allows the base unit to
try to reconnect the Bluetooth devices at
regular intervals when it returns within base
unit range. You can set the interval. The
default setting is "1 min".
For assistance, please visit http://shop.panasonic.com/support
20
Important:
R Only 1 Bluetooth device can be used with
the unit at a time, and the base unit loses
its connection from other Bluetooth devices.
To automatically resume the connection to
Bluetooth devices, leave the auto
connection on.
R Some cellular phones lose connection after
usage, please check the specifications of
your cellular phone for more details.
1
MMENUN#632
2
MbN: Select the desired setting. a
MSAVEN a MOFFN
Note:
R Some cellular phones may ask you if you
accept the connection requirement from the
base unit. In that case, select "Off" in step
2. Check the specifications of your cellular
phone.
Connecting/disconnecting the
cellular phone manually
If you will not be using the paired cellular
phone's link to cell feature temporarily (for
example, you do not want the unit to ring
when your cellular line receives a call), you
can disconnect your cellular phone from the
base unit. If you want to use it again,
reconnect the cellular phone to the base unit.
Note:
R After you disconnect a paired cellular
phone from the base unit manually, it will
automatically be connected to the base unit
in 30 minutes. If you do not use the link to
cell feature anymore, unpair the cellular
phone (page 20).
R A disconnected cellular phone is not
unpaired from the base unit, so pairing it to
the base unit again is unnecessary.
1
To connect/disconnect:
For CELL 1: MMENUN#6251
For CELL 2: MMENUN#6252
R A long beep sounds.
2
MOFFN