Answering Calls; Useful Features During A Call - Panasonic KX-TGE662 Operating Instructions Manual

Making/Answering Calls Using the Handset
To switch back to the receiver, press MZN/
M N.
R In step 1, you can store the dialed phone
number to the phonebook by pressing and
holding MFN W for a few seconds.
Making a call using the redial list
The last 5 phone numbers dialed are stored in
the redial list (48 digits max. each).
1
MEN REDIAL
2
MbN: Select the desired entry.
3
M N
Pause (for PBX/long distance service
users)
A pause is sometimes required when making
calls using a PBX or long distance service.
When storing a calling card access number
and/or PIN in the phonebook, a pause is also
needed (page 42).
Example: If you need to dial the line access
number "9" when making outside calls with a
PBX:
1
9 a MDN (Pause)
2
Dial the phone number. a M
Note:
R A 3.5 second pause is inserted each time
MDN (Pause) is pressed.

Answering calls

When a call is being received, the ringer
indicator flashes rapidly.
1
Lift the handset and then press M
MZN when the unit rings.
R To answer a cellular call, you can also
press MCELLN.
2
When you finish talking, press MOFFN or
place the handset on the base unit or
charger.
Any key answer: You can answer the call by
pressing any dial key (except 0 key).
Auto talk: You can answer calls simply by
lifting the handset (page 50).
For assistance, please visit http://shop.panasonic.com/support
24
Temporary handset ringer off: You can turn
the ringer off temporarily by pressing M
soft key).
Adjusting the handset ringer volume
n While the handset is ringing for an
incoming call:
Press MjN or MkN repeatedly to select the
desired volume.
n While the handset is in standby mode:
Press MjN or MkN repeatedly to select the
desired volume for landline call.
R To turn the ringer off, press MkN repeatedly.
Note:
R You can adjust the ringer volume for
cellular call and landline call by
programming (page 46, 48).
R The ringer volume you set is kept for each
line (landline and cellular lines).
One-touch ringer off for the handset
Press and hold 0 (
turn the ringer off. While the ringer is turned
off, the handset will not ring for calls.
R You can turn the ringer on again by:
– pressing and holding 0 (
N
unit beeps
– pressing MjN repeatedly
Useful features during a
call
Hold
1
N or
Press MMENUN during an outside call.
2
MbN: "Hold" a MSELECTN
3
To release hold on the cellular line:
Press MCELLN.
R Another handset user can take the call
by pressing MCELLN.
*1
) until the unit beeps to
) until the
*1
*1
If you press MCELLN and the
selection list is displayed, select
the desired cellular line and press
MSELECTN.
N (left