Removing Or Replacing The Switch - IBM EN4093R User Manual

13. Attach any cables that are required by the switch. For additional information
14. Make sure that the external ports on the switch are enabled through one of the

Removing or replacing the switch

Note: The following illustration shows how to remove and replace the switch from a
To replace the switch, complete the following steps.
1. Read the safety information that begins on page v, and "Installation guidelines"
2. Disconnect any cables from the switch that you are removing. Removing these
3. Pull the release latches out from the switch. The switch moves out of the bay
4. Slide the switch out of the bay and set it aside.
5. Place either another switch or a filler module in the bay.
8
EN4093 and EN4093R 10 Gb Scalable Switch: User's Guide
about cabling the switch, see "Cabling the switch, the SFP+ and the QSFP+
module" on page 12, the documentation that comes with the cables, and the
optional network adapters to which the cables have been connected. For the
locations of the connectors on the IBM Flex System chassis, see the
documentation that comes with the IBM Flex System chassis. Then, continue
with the next step.
Chassis Management Module (CMM) interfaces, such as the Web-based
interface or the CLI.
IBM Flex System chassis. The appearance of your IBM Flex System chassis
might be different; see the documentation for your IBM Flex System chassis
for additional information.
on page 5.
cables (especially an Ethernet cable) disrupts the network connection from the
external Ethernet port to any connected external Ethernet devices. If you plan to
replace the switch with another switch, you can use the existing Ethernet cable,
provided that it remains securely attached to the Ethernet network. For
additional information about cabling the switch, see "Cabling the switch, the
SFP+ and the QSFP+ module" on page 12, the documentation that comes with
the cables, and the optional network devices to which the cables have been
connected.
approximately 0.6 cm (0.25 inch).
Important: Complete this step within 1 minute. (For more information, see steps
9 and 10 on page 7.)