Keystone - Eiki EK-308U Owner's Manual

Keystone

This function is used to store or reset the
keystone correction when the AC power cord is
unplugged.
1 Press MENU button on the remote control
to display screen menu. Press  button
to select "Expand", then press the OK button.
2 Press button to select "Keystone", press
the OK button.
3 Press button to select the item you want
to set, press the OK button.
Keystone
Sets whether or not to keep the keystone
correction after turn off the projector or plug out
the power cord.
Store ..... The keystone correction will be kept when plug out the power cord or turn off the
projector.
Reset .... The keystone correction will be reset.
 Note:
When you select "Store", it is recommended to select "Manual" or "Off" in Auto Keystone of Auto setup.
(Refer to Page 44)
H/V Keystone
Adjust when the horizontal or vertical trapezoid of the projected image is distorted.
Reduce the upper
width with  button.
Corner correction
Adjust when the four corners of the projected image are distorted.
Press▲▼◄►to adjust the item.
Upper left
 Note:
● The white arrows indicate that there is no correction.
● A red arrow indicates the direction of correction.
● An arrow disappears at the maximum correction.
Expand
Reduce the lower
width with  button.
Corner correction
Upper right
Keystone menu
Expend
Keystone
Keystone
H/V Keystone
Corner correction
Curved correction
Reset value
Reduce the left
width with  button.
Lower left
Store
Reduce the right
width with  button.
Lower right
45