Table of Contents
Advertisement
Installation
The Cordless Scanner is easy to install and use. Please see
the following figure showing the steps to perform the
installation.
* Note: Turn off the host computer before installation.
1.
Connect the interface (I/F) cable to the cradle.
2.
Connect the power cord to the cradle.
3.
Route the I/F cable and power cord through the notch.
4.
Connect the I/F cable to the host computer
communication port.
5.
Connect the AC adapter to the wall outlet.
6.
Place the imager in the cradle and verify the charge
LED is flashing. Charge the battery for at least 8 hours
before the first use.
7.
To verify operation, please link the imager with cradle
first (Refer to "Wireless Connection" in page 5). Point
the imager at the barcode and pull the trigger. The
8
Advertisement
Table of Contents
