Parallel Interface Requirements; Serial And Parallel Cabling Requirements; Communicating With The Printer; Before Installation - Argox amigo series User Manual

Parallel Interface Requirements

The required cable must have a standard 36-pin parallel
connector on one end, which is plugged into the parallel port
located on the back of the printer. The other end of the parallel
interface cable connects to the printer connector at the host
computer. For pin-out information, please refer to Technical
Reference, Interface Specifications in this manual.

Serial and Parallel Cabling Requirements

Data cables must be of fully shielded construction and fitted with
metal or metalized connector shells. Shielded cables and
connectors are required to prevent radiation and reception of
electrical noise.
To minimize electrical noise pickup in the cable:
Keep data cables as short as possible (6 ft or 1.83m

recommended).
Do not tightly bundle the data cables with power cords.

Do not tie the data cables to power wire conduits.

Notes:
1. Centronics allows a much higher communication speed
than serial.
2. The printer automatically detects parallel or serial port.
No need to set a switch or send a command.
3. Default settings are included in the configuration report.
37

Communicating with the Printer

The bundled printer driver can be applied to all applications under
Windows 98/2000/2003/Windows XP and Windows Vista. With
this driver you can run any popular Windows software
applications such as MS-Word and print out to this printer.

Before installation

1. Check the contents of the driver to ensure it is complete.
2. Make a backup copy of this driver.
Installing the Printer Driver (Label Dr.200 or Label
Dr. 300)
1. Double click the driver file
(Label Dr. 200 or Label Dr. 300)
to execute in Windows.
2. Click "Next".
38