Brother VM5200 Operation Manual page 304

ERROR MESSAGES
Marks
This stitch is not "Dual Feed Mode" compatible.
This USB media cannot be used.
This USB media is incompatible.
To thread the needle, please remove the fabric from under the
presser foot.
Transmitting by USB
Turn off the power and replace the needle plate.
USB media error
USB media is not loaded. Load USB media.
Use the presser foot lifter button to lower the presser foot.
When the speed controller is set to control the zigzag stitch
width, the "Start/Stop" button does not operate.
A-36
Error Messages Cause/Solution
This message appears when the optional dual feed foot
cannot be used with the current stitch. Select other stitch. (see
page B-67)
This message is displayed when you try to use incompatible
media.
This message is displayed when you try to use incompatible
USB media. For a list of compatible USB media, visit
" http://support.brother.com ".
This message is displayed if you press the "Automatic
Threading" button while the dual feed foot is attached and the
presser foot height is 3 mm (1/8 inches) or higher.
Remove the fabric, and then press the "Automatic Threading"
button again.
This message is displayed while the USB media is
transmitting.
This message is displayed when you try to sew with a stitch
other than a middle needle position stitch while the single-hole
needle plate is installed.
This message is displayed when the needle plate is removed
with the machine on or when the machine is turned on and
"Embroidery" or "Embroidery Edit" mode is selected (see page
B-22).
This message is displayed when an error occurs with the USB
media.
This message is displayed when you try to recall or save a
pattern while no USB media is loaded.
This message is displayed when a button, such as the
"Start/Stop" button, is pushed while the presser foot is raised.
This message is displayed when the speed control lever is set
to control the zigzag stitch width, and the "Start/Stop" button
is pushed. Use the foot controller to operate the machine.