Receiving - Kenwood NX-5300E2 User Manual

2
Press the [J] and [K] keys to select a unit ID from the list that has been pre-
entered into your transceiver.
Alternatively, on full key models, you can enter a unit ID directly by pressing the keypad.
Press the [
●
To delete the code entered, press the [
the [ ] key to delete all digits.
3
Press and hold the PTT switch to make the call.
"Individual" and the ID name of the target transceiver are displayed. "Calling" appears
●
on the display while the call is being made, and disappears once the call is established.
Speak into the transceiver as you would during a normal call.
●

RECEIVING

1
Select the desired zone and channel using the Selector knob and the [Zone
Up]/ [Zone Down] or [Channel Up]/ [Channel Down] keys. (If the Scan function
has been programmed, you can switch it on or off as desired.)
2
When you hear the caller's voice, readjust the volume as necessary.
If signaling has been programmed on the selected channel, you will hear a call only if
●
the signal tone matches the tone set up on your transceiver.
Note:
Signaling allows your transceiver to code your calls. This will prevent you from listening
●
to unwanted calls. It does not make calls private, it only prevents them from being heard
by transceivers set with a different signaling code. Refer to "SIGNALING" {p. 47} for
details.
A ringing tone will sound when receiving a call if the alert tone has been enabled in the
●
Alert Tone setting. For details, consult your dealer.
12
] key to enter the manual input mode.
] key to delete one digit, or press and hold