Table of Contents
Advertisement
2
Select the new Encryption key using the [J] and [K] keys.
Up to 32 Encryption keys can be used. One of these keys will be used during
●
transmission.
3
Press the [ ] or [ ] key to set the new Encryption key.
Note:
The selecting of encryption key is not available in P25 Trunking systems.
●
In NXDN systems, the encryption function does not work when a Key ID which is 0x40
●
and above is selected.
To restore to the default Encryption key, select "Preset". However, if you delete the
●
Encryption key, it will not be recovered.
DELETING THE ENCRYPTION KEY (AES (SCM*)/ DES (Built-in-DES or
SCM*) and Enhanced Encryption only)
1
Press the key programmed as [Key Delete] to enter Key Delete Mode.
Alternatively, press the key programmed as [Menu] to enter Key Delete Mode using the
Menu Mode.
2
Select the current Encryption key using the [J] and [K] keys.
3
Press the [
] or [#] key to delete the Encryption key.
4
Press the [ ] or [ ] key to confirm and exit Key Delete Mode.
Note:
To delete all Encryption keys (when more than one key has been set up), press and hold
●
the [
] or [#] key for 1 second.
PASSWORD PROTECTION
If the transceiver is password protected, entering an incorrect password successively
15 times will automatically delete all the Encryption keys.
Turning the transceiver power OFF and the ON again will not reset the number of attempts
●
for entering an incorrect password.
46
Advertisement
Table of Contents
