Making An Espresso - Krups XP228050 Manual

n Turn the knob to "0" position.
In this manner you can be sure that water is circulating well through the filter cartridge.
IMPORTANT:
This installation procedure must be carried out every time the cartridge is
replaced.
The Claris cartridge needs to be replaced every 2 to 3 months if it is used daily.
C. RINSING YOUR APPLIANCE (to be done on first use and after each cleaning /
descaling operation)
- RINSING OUT THE ESPRESSO CIRCUIT
n Turn on the appliance and fill the water tank (Fig. 1, 2, 3 & 4).
n Insert the filter holder (without ground coffee) in the appliance (Fig. 7).
n Place a container of sufficient volume under the filter holder.
n As soon as the appliance reaches the right temperature, the
pictograms and
n Press the
button and let the water run out into the container (fig.9).
n Repeat this operation 5 times.
n If necessary, stop the operation by pressing the
the operation (fig.9).
n Empty the container and unlock the filter holder: press the "OPEN" button on the filter holder and
turn it to the left (fig.10).
- RINSING OUT THE STEAM CIRCUIT.
Before using the steam function for the first time, the steam circuit should be cleaned.
n Fill the water tank. Make sure that the steam function dial is in O position.
n Turn the appliance on by pressing the
n Place a container underneath the steam nozzle.
n When the Espresso
light indicator glows, press the
on the display will begin to blink.
n When they have stopped blinking, turn the dial to the
steam is generated.
n Keep the steam production going for at least 30 seconds.

2 . MAKING AN ESPRESSO

Before making an espresso, make sure the steam knob on the left of the appliance is in 0
position.
In order to release all the aromas of the coffee and ensure your complete satisfaction, this machine pre-
brews each coffee. The pump works for 3 seconds, stops the following 3 seconds and then the cycle
continues until the end of the preparation.
PREHEATING THE ACCESSORIES
n For best results, we recommend that you first pre-heat the accessories (filter holder and cups)
without ground coffee. To do this:
n Fill the water tank and turn on the appliance (Fig. 1, 2, 3 and 4).
n Put the filter holder in place and place the cups underneath.
n As soon as the appliance reaches the right temperature, the
pictograms and
n Then press the
or
n Once the cup(s) are filled with hot water, remove them.
n Unlock the filter holder: press the "OPEN" button by turning the filter holder to the left and remove
it from the appliance.
are displayed.
Espresso
button.
are displayed.
button (fig.8 ou 9).
Espresso
LED glows steadily and the
button to empty the container and then resume
Espresso
button: the light indicator and the
position and allow the water to flow until
Espresso
LED glows steadily and the
English
pictogram
6