Krups XP228050 Manual page 15

n Press the
Espresso
button (fig.4).
n Once the
Espresso
LED becomes steady, turn the knob to
the nozzle and then turn it back to "0" position
n The appliance is descaled and ready to be used again.
6. TROUBLESHOOTING
Problems
The espresso is not
hot enough.
Espresso
The LED and
the pictograms
and flash and
the appliance does
not work.
The filter holder is
blocked
The grounds are not
dry after water has
run through.
The espresso flows
too slowly.
The water does not
run through.
Water leaks from
the filter holder after
an espresso has
been made.
Coffee grounds in
the cup.
Possible causes
The cups and the filter
holder are cold.
The knob has been turned
to the position.
You forgot to unlock the
filter.
You have not tightened the
filter holder properly.
The espresso ground coffee
is too fine, too oily or floury.
The flow rate depends on
the fineness of the coffee
used and can vary when
preparing the espresso
The filter holder is dirty.
The water drip-through grid
is clogged.The water drip-
through grid is clogged.
No water in the tank.
Tank poorly fitted.
The filter is clogged. The
espresso ground coffee is
too fine.
Your device is scaled up.
The Claris cartridge has
been replaced but not
primed.
Premature formation of
scale due to especially hard
water.
The filter holder is clogged.
The grind is too fine.
position and let 100 ml of water flow through
Solutions
Preheat the accessories: cups and filter holder
(see paragraph 6).
Turn the knob to the "0" position (fig.15).
Press the "OPEN" button lightly while turning the
filter holder to the left.
Tighten the filter holder further by turning it to the
right as far as possible, up to the stop.
Choose a slightly coarser espresso ground
coffee
Clean your filter holder (see paragraph 4).
When the appliance has cooled, clean the
brewing head with a damp cloth. (fig.21).
Fill the tank.
Press down firmly on the tank.
Clean the filter holder (see paragraph 4) and try a
less fine espresso grind.
See paragraph 5.
See paragraph 1
Descale your appliance according to the manual
(see paragraph 5).
Clean the filter holder with hot water. Press
"EJECT" to eliminate the remnants of the
grounds. Shake to drain the water.
Use a slightly coarser espresso grind.
English
12