Multi-Projection Function
(2)
Adjust the lens shift.
s "Adjusting the Position of the Projected Image (Lens Shift)"
(3)
Adjust the zoom and focus.
s "Adjusting the Image Size"
s "Correcting the Focus"
p.39
(4)
Adjust small differences in the images.
s "Point Correction"
p.76
(5)
Adjust the edges of the images.
s "Edge Blending"
p.98
s "Black Level"
p.100
(6)
Adjust the brightness and tint of the images.
s "Screen Matching"
p.103
(7)
Select the sections of the images.
s "Displaying a Scaled Image"
Adjusting manually offline
Adjust the images from all projectors manually.
Advance preparation
(1)
Turn on all projectors.
(2)
Set an ID for all projectors and the remote controls.
s "Set the projector ID"
p.44
Adjusting the projected position
(1)
Adjust the position (angle) of the projector.
s "Installation Settings"
p.30
(2)
Adjust the arrangement of the images.
s "Performing tiling manually"
p.34
p.38
p.106
p.97
Adjusting the projected images
"Adjusting the projected images"
s
Tiling
Project the same image from multiple projectors to create one large image.
You can project by using up to nine projectors.
a
Before performing tiling, adjust the projected image so that it is a
rectangle. Also, adjust the size and focus of the images.
s "Adjusting the Image Size"
s "Correcting the Focus"
Performing tiling automatically
This section explains how to select the projector being used in Projector
Grouping, and then automatically configure the images being projected.
a
Location setup is performed using the camera built into the front of
the projector. Do not block the camera or the projected images.
p.94
p.38
p.39
95