Epson EB-L1750U User Manual page 153

List of Functions
Submenu
s "Hiding the Image and Sound Temporarily (A/V
Mute)" p.111
Advanced: The following items can be set.
• BNC Sync Termination: Set the termination for the
signal from the BNC port. This should usually be set to
Off. Set to On when analog (75Ω) termination such as for
switchers is necessary.
• Remote Control Type: You can select Normal or Simple
depending on the type of remote control.
Set this item to Normal to use the remote control
provided with this projector. When Simple is selected, you
can use the remote control provided with other Epson
projectors to operate this projector. This is useful if you
want to use a remote control that you are already familiar
with to operate the projector.
However, you cannot use the remote control provided
with this projector if this is set to Simple. Make sure that
the setting is correct because, if the projector is mounted
on the ceiling or somewhere hard to reach, changing it
back to Normal may be difficult. Additionally, you cannot
use the functions that are not equipped with this projector
or the remote control which you use.
• Beep: When this is set to On, the confirmation buzzer
beeps to notify you that the power turns on or off, or
cooling down is finished.
• Indicators: When set to Off, the projector's indicators are
turned off, except for abnormality or warning.
• Log Save Destination: Set the save location for the
projector's operation logs. Select USB and Internal
Memory to save logs to the USB flash drive connected to
the projector's USB-A port. Logs are saved as text files
(.log) to the USB flash drive.
• Instant Off: When set to Enabled, the projector goes into
standby status in approximately three seconds after Power
Off. If you turn the power on immediately after turning it
off, command communication may be cut off. To stabilize
Function Submenu
command communication, set this to Disabled. When set
to Disabled, the projector goes into standby status in
approximately 75 seconds after power off.
• Inv Direction Button: Set this to On when the projector
is installed on a ceiling.
• AC Voltage Monitoring: When this is set to On, and the
projector is turned off by any method (including direct
shutdown) except for pressing the power button, an AC
Voltage Waring dialog is displayed the next time the
projector is turned on. Set this to Off if you use direct
shutdown regularly.
• Lens Type: When using the following lens, select the
model number of the lens.
ELPLS04, ELPLU02, ELPLR04, ELPLW04, ELPLM06,
ELPLM07, ELPLL07
Date & Time: Make system time settings for the projector.
s "Setting the Time"
Lens Calibration: Acquires the information of the lens
installed on the projector.
153
Function
p.45