HIKVISION DS-2AE5232TI-A User Manual page 29

User Manual of HD-TVI Speed Dome
This feature enables the live view to switch directly from the current scene to another scene that is
defined by a preset, without showing the middle areas between these two scenes. It reduces the
use of bandwidth in a digital network system and it also provides privacy protection for the middle
areas.
You can set PRESET FREEZING as ON or OFF to enable or disable this function.
The function varies according to the different camera models.
 PTZ speed
Purpose:
You can define the speed of the dome movements.
(1) DOME SPEED: The manual movement speed of the dome can be set from level 1 to 10.
(2) SCAN SPEED: The scan speed defines the scan degree per second of pan scan, tilt scan, frame
scan, random scan and panoramic scan. The scan speed is adjustable from level 1 to level 40 and
the higher the level is, the faster the scan speed is.
(3) PRESET SPEED: The speed of calling a preset can be set from level 1 to 8. The higher level
corresponds to the faster speed to call a preset.
 Setting Limits
Purpose:
The limits are user-configurable positions which limit the panning and tilting area of the speed
dome. There are left, right, up and down limits to define an area.
Steps:
1. Move the cursor to ENABLE LIMIT and click FOCUS+ to set it ON to enable this feature. Click
IRIS+ to confirm the new settings.
2. Move the cursor to LIMIT SETTING and click IRIS+. You will see the message SET LEFT LIMIT on
the screen.
3. Click the direction buttons in the PTZ panel to configure the left limit. Click IRIS+ to confirm the
new settings.
4. Follow the prompts to configure the right, up and down limits on the menu.
The new limit will overwrite the existed ones by default.
5. You can clear the defined limits. Click IRIS+ to enter CLEAR LIMITS and click IRIS+ again to clear
the stops.
 Elevation set
You can set the SET ELEVATION as ON to increase the elevation angle range of the speed dome or
set it as OFF to disable the function.
The range of the elevation angle is 0~90° by default and it changes to -15°~90° after the
ELEVATION SET is set as ON.
28