HIKVISION DS-2AE5232TI-A User Manual page 20

User Manual of HD-TVI Speed Dome
CAMERA
WB MODE
RED
BLUE
IMAGE FLIP
FOCUS LIMIT
2D DNR
3D DNR
BACK
Task 1: Configure the focus settings.
 Setting the focus mode
Steps:
(1) Move the cursor to FOCUS using the direction buttons and click IRIS+ to enter.
(2) Click up/down direction buttons to set the focus mode to AF, MF or HAF.
AF (Auto-focus): The lens remains in focus during PTZ movements.
MF (Manual Focus): You need to adjust the focus with Focus+ and Focus- buttons manually.
HAF (Half-auto Focus): The speed dome focuses automatically only once after panning,
tilting and zooming.
(3) Click IRIS+ button to save the settings.
 Setting the focus limit
Purpose:
This function is used to limit the minimum focus distance. You can configure the focus limit
longer when the target is at a distance, to avoid the speed dome focusing on the objects close to
it; or configure the focus limit shorter when the target is near the speed dome, and avoid it
focuses on the objects father.
You can set FOCUS LIMT to 1CM, 30CM, 1M, 3M, 5M and AUTO to make sure that the speed
dome focuses on the target.
The focus limit value varies according to the models of speed dome.
Task 2: Configure the zoom settings.
 Setting the zoom limit
Purpose:
Zoom limit is a user-defined limitation of the zoom amount (Zoom amount=optical zoom× digital
zoom). If you set the zoom limit to the minimum value, the digital zoom will be invalid and the
optical zoom will reach the maximum value; if you set the zoom limit smaller, the digital zoom
will be enabled.
Steps:
(1) Move the cursor to ZOOM LIMIT using the direction buttons and click IRIS+ to enter.
(2) Click up/down direction buttons to choose the limit from 23, 46, 92, 184, and 368.
(3) Click IRIS+ button to confirm.
AUTO MIN. ZOOM LIMIT
210 CHROMA SUPPRESS
150 SATURATION
OFF CONTRAST
1M SCENE MODE
1 HLC
2 SHARPNESS COMP
EXIT
Figure 3-7 Camera Settings
CAMERA
2.0
1
1
OFF
INDOOR
ON
15
BACK EXIT
CAMERA
GAIN LIMIT 15
DEFOG OFF
INIT LENS OFF
BACK EXIT
19