Appendix B: Releasing Zones; B.1: Introduction - Honeywell NOTIFIER NFS2-3030 Operation Manual

B.1 Introduction
The control panel provides ten Releasing Zones (ZR00-ZR09). These are special zones that can be
used for up to ten independent releasing operations. This section contains descriptions of each
releasing function option and an example of how Releasing Zone options work.
For instructions on programming Releasing Functions, refer to this panel's programming manual.
Each Releasing Zone includes the following releasing options:
Option
Cross Zone
Delay Timer
Abort Switch
Manual Release
Soak Timer
The Read Status function allows the operator to view the current selections for a Releasing Zone.
Refer to Section 3.8, "Releasing Zone", on page 46 for more information.
NFS2-3030 Operations Manual — P/N 52546:A 11/29/2005

Appendix B: Releasing Zones

Description
Cross Zones let you program the control panel to activate a Releasing Zone when
two or more detectors are alarmed. Cross Zone selections are:
Yes Two or more detectors are alarmed that are mapped to one of the ten
Releasing Zones (ZR00-ZR09).
Zone Two or more detectors are alarmed that are mapped to two different
Software Zones and mapped to one of the ten Releasing Zones (R0-R9).
Heat At least one smoke detector mapped to one of the ten Releasing Zones
(ZR00-ZR09) is alarmed and at least one heat detector mapped to the same
Releasing Zone as the smoke detector is alarmed.
None Cross Zones are not used.
A 0–60 second programmable delay before activating a zone.
An Abort Switch Type Code used to abort activation of a zone.
Allows immediate zone activation by overriding the abort function, cross-zone
function, and delay timer.
Automatically shuts off the releasing device after a preprogrammed period of time.
Select 0001-9999 seconds for Soak Time or 0000 seconds for no Soak Time.
Table B.1 Releasing Options
67