Operation - Dometic DRAWBAR Series Operating Manual

Description of the device
No in
fig. 1,
Explanation
page 3
1 Temperature indicator LEDs
2
On/off button
3
Setting button
4 Glass front panel with handle
(DrawBar5B, 5C only)
5 Humidity tray
6 Interior LED lamp
7 Rubber strips
8 Spacer
9 Mounting plate

Operation

Before first use
➤Clean the wine cooling drawer inside and out-
side for hygienic reasons (see chapter "Cleaning
and maintenance" on page 9).
➤Fill the humidity tray with water at least until the
sponge is completely covered (fig. 7, page 4).
Saving energy
• Only open the wine cooling drawer as often and
for as long as necessary.
• Avoid unnecessarily low temperature settings.
• On a regular basis, make sure the drawer seal still
fits properly.
• Clean dust and dirt from the condenser at regu-
lar intervals.
Switching on and off
➤To switch on, press the
page 3).
➤To switch off, press and hold the
at least 2 seconds (fig. 3, page 3).
8
button once (fig. 2,
button for
4445103438
Setting the temperature
To avoid food waste, note the following:
• Keep temperature fluctuation as low as possible.
Only open the wine cooling drawer as often and
for as long as necessary. Store the wine bottles in
such a way that the air can still circulate well.
• Adjust the temperature to the quantity and type
of the wine bottles.
The wine cooling drawer is set by default to a cool-
ing temperature of 11 °C.
➤To set the temperature, press the
repeatedly until you reach the desired tempera-
ture level (fig. 4, page 3).
Using the presentation mode
With presentation mode activated the interior LED
lamp stays on permanently.
➤To activate and deactivate the presentation
mode, press simultaneously the
button for at least 2 seconds (fig. 5,
the
page 4).
✔ All temperature indicator LEDs flash for 1 time.
Using the demo mode
With demo mode activated the compressor and
fans are switched off.
➤To activate the demo mode, press the
button for at least 6 seconds (fig. 6,
page 4).
✔ All temperature indicator LEDs flash for 3 times.
✔ The temperature indicator LEDs for 11 °C and
14 °C light up permanently.
➤To demonstrate the temperature setting func-
tion or the presentation mode, press the
button once.
✔ The temperature indicator LEDs for 11 °C and
14 °C turn off within 2 seconds.
✔ The temperature indicator LED of the last
selected temperature level lights up.
➤To deactivate the demo mode, press the
button for at least 6 seconds (fig. 6,
page 4).
✔ All temperature indicator LEDs flash for 3 times.
✔ The temperature indicator LED of the last
selected temperature level lights up.
button
button and