Chapter 2: Removing And Installing Components; Recommended Tools; Screw List - Dell Latitude 7530 Service Manual
Hide thumbs
Also See for Latitude 7530:
- Service manual (100 pages) ,
- Setup and specifications manual (26 pages) ,
- Assembly installation manual (16 pages)
Table of Contents
Advertisement
Removing and installing components
NOTE:
The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Phillips screwdriver #1
● Plastic scribe
Screw list
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE:
Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE:
Screw color may vary with the configuration ordered.
Table 1. Screw list
Component
Base cover
3-cell battery/4-cell battery
M.2 2230/2280 solid-state
drive (SSD) thermal plate
WWAN-card bracket
Thermal module
Display-cable bracket
WLAN-antenna module bracket
Darwin bracket
Display-cable bracket
10
Removing and installing components
Screw type
Captive screws
NOTE:
Screws are
part of the base
cover.
Captive screws
M2x2
M2x2.5
M2x2.5
● M2x2
● M2x2
● M2x2.5
Quantity
8
3
2
1
6
● 2
● 1
● 1
Screw image
●
●
●
2
Advertisement
Table of Contents
