Steps
1. Place the power button with optional fingerprint reader into its slot on the palm-rest and keyboard assembly.
2. Adhere the fingerprint reader flexible printed circuits to the connector on the system.
NOTE:
This step applies only to computers shipped with a power button with fingerprint reader installed.
3. Align the screw hole on the power button with optional fingerprint reader to the screw hole on the palm-rest and keyboard
assembly.
4. Replace the two screws (M1.6x1.7) to secure the power button with optional fingerprint reader to the palm-rest and
keyboard assembly.
Next steps
1. Install the
system
board.
2. Install the
thermal
module.
3. Install the
WWAN
card, if applicable.
NOTE:
This procedure applies only to computers shipped with a WWAN card installed.
4. Install the
M.2 2230 solid-state drive
5. Install the
base
cover.
6. Install the
microSIM-card
7. Follow the procedure in
Keyboard
Removing the keyboard
Prerequisites
1. Follow the procedure in
2. Remove the
microSIM-card
or the
M.2 2280 solid-state
tray.
After working inside your
Before working inside your
tray.
drive, whichever applicable.
computer.
computer.
Removing and installing components
79