Transport And Storage; Troubleshooting - Hilti PR 2-HS A12 Manual

8

Transport and storage

8.1 Transport and storage
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Transport the tool and battery individually packaged.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check tools and batteries for damage before use after long periods of transport.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and battery in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
9

Troubleshooting

If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
The tool doesn't work.
The battery runs down more
quickly than usual.
The battery doesn't engage
with an audible click.
The tool or battery gets very
hot.
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
*2131237*
Possible cause
The battery is not fully inserted.
Battery is discharged.
Very low ambient temperature.
The retaining lugs on the battery
are dirty.
Electrical fault.
2131237
Action to be taken
▶ Push the battery in until it
engages with an audible click.
▶ Change the battery and charge
the empty battery.
▶ Warm up the battery slowly to
room temperature.
▶ Clean the retaining lugs and refit
the battery.
▶ Switch the tool off immediately,
remove the battery, keep it
under observation, allow it to
cool down and contact Hilti
Service.
English 11