Allied Telesis CentreCOM FS980M Series Quick Installation Manual page 26

5. Enter the default user name and password. They are "manager"
and "friend" (without quotes), respectively. The user name and
password are case sensitive. The local management session
starts when the User Exec mode prompt is displayed: awplus>.
For more information, refer to the
Series Switches, AlliedWare Plus Operating
FS980M
System
from www.alliedtelesis.com/us/en/services-support.
Disabling the VCStack Feature
The SFP S1 and S2 ports can function either as regular Ethernet SFP
ports or as stacking ports for the VCStack feature. At their default
settings, the SFP S1 and S2 ports are VCStack stacking ports. To
use them as regular Ethernet SFP ports, you have to disable the
VCStack feature.
Note: The FS980M/9, FS980M/9PS, FS980M/18, and FS980M/
18PS Switches do not support the VCStack feature.
To disable VCStack, perform the following procedure:
1. Start a local management session. Refer to "Starting a Local
Management Session" on page 25.
2. Enter the commands in bold:
awplus> enable
awplus# configure terminal
Enter configuration commands, one per line. End
with CNTL/Z.
awplus(config)# no stack 1 enable
3. At the confirmation prompt, type Y for yes to disable VCStack,
4. Enter the commands in bold:
awplus(config)# exit
awplus# write
Building configuration ...
{OK}
awplus# reboot
5. Wait two minutes for the switch to start the management software
The switch in now in standalone mode. The SFP S1 and S2 ports
are now regular Ethernet ports.
6. You can now cable the SFP S1 and S2 transceiver ports.
26
Command Reference for
CentreCOM FS980M Series Quick Installation Guide