Allied Telesis CentreCOM FS980M Series Quick Installation Manual page 15

Warning: The device should be installed on the wall by a
qualified building contractor. Serious injury to yourself or
others or damage to the equipment may result if it is not
properly fastened to the wall.  E105
Caution: The supplied screws and anchors might not be
suitable for all walls. A qualified building contractor
should determine the hardware requirements of your wall
prior to installing the switch.
To install the switch on a wall, perform the following procedure:
1. Place the switch on a table.
2. Attach the brackets to the sides of the switch with the eight
supplied screws.
Note: For the FS980M/18PS, FS980M/28, and FS980M/52
Switches, perform steps 3 to 5. You have to attach two plastic feet
to fill the gap between the switch and the wall. For all other FS980M
Switches, go to step 6.
3. Turn over the switch on a table.
4. Attach two feet at the corners opposite the brackets.
CentreCOM FS980M Series Quick Installation Guide
E88

15