Maintenance & After Use; Warranty - Takuma e-foil jet User Manual

Table of Contents

MAINTENANCE & AFTER USE

Maintain your E-FOIL JET after each use:

The TAKUMA E-FOIL JET needs to be checked regularly and

maintained to ensure good working order and to reduce the risks of

degradation.

Never allow sand and/or seawater to get in the connectors or it

may cause significant damage.

Always make sure the connectors are clean and dry and apply

connector grease regularly.

Check your E-FOIL JET thoroughly after each use to make sure

everything is OK (screws, cover etc.)

Only pack your E-FOIL JET away after it is completely dry. Before

storage, always check that it is completely dry.

Apply TEF GEL on the screws regularly.

If needed, contact your TAKUMA authorized dealer for assistance.

After each use, rinse your E-FOIL JET: Open the top cover of the board and

rinse with fresh water without disconnecting the cables.

Also rinse the Jet propulsion mast and the impeller.

Dry the inside of the board with a clean dry cloth until there is no sign of water

left.

Also dry the Jet ESC, battery and connector caps.

If the connectors get wet, rinse them with clean fresh water, then use a canister

of compressed air to blow out the water. Once its completely dry, apply a

thin layer of connector grease such as dielectric grease or NyoGel®. Once the

connector caps are dry, screw them directly back onto the connectors.

Remove the battery. Dry it completely and store it in a dry place.

Storage

Do not place the battery directly on sand or immerse in water. Keep the

battery and remote control out of direct sunlight.

Once the battery is charged, disconnect. Do not store the battery on

continuous charge.

For optimum battery lifespan, we recommend you charge the battery every

3 months to 80% if storing for a long period of time.

Best temperature for battery storage is between 10-25°C.

Please refer to our website to review our warranty policy:

takuma.com

Table of Contents