Table of Contents
Advertisement
Registering the deskset - Manual registration (triggered via LINK button on base)
1.
Make sure the base station is connected to power and the network.
2. Press the Setting key OR the User Settings function key.
The User Settings screen appears.
3. Press
or
The Registration screen appears.
4. With This device selected, press OK.
The "This device" screen appears.
5. With The base LINK key selected, press OK.
The handet displays:
Press and hold the LINK key
Then, press the # key at the deskset.
6. Press and hold the LINK button on the base station for four seconds.
The
(power) and
7. Press the # key on the deskset to begin registration.
The deskset briefly displays "Press the WPS button on your Hub .
The deskset displays "Registering... Please Wait."
8. If you are promted to enter a PIN, enter the PIN and then press OK.
The default PIN is 0000.
If registration is successful:
The deskset beeps and displays "Deskset X Registered" .
If registration fails:
The deskset displays "Registration failed". Press OK.
• If the deskset displays "Device not registered to base station.",
press Reg. Place the deskset in the charger again for a few seconds,
remove it and try the registration steps again.
• If the deskset displays "Out of range. Searching for base...", move the
deskset closer to the base, and try the registration steps again.
• If the deskset displays the idle screen, it means the deskset was
already registered to another base. To register the deskset to a different
base, try the registration steps again.
to scroll down to Registration and press OK.
at base for 4 seconds
(SIP) LEDs flash green.
17
Advertisement
Table of Contents
